cara mbuat bros

32
1. Sediakan bahan-bahan standar buat bikin kerajinan flanel… Kain flanel, lem uhu dan kawat (untuk dibikin sungutnya si kupu) 2. Gunting kain flanel sesuai bentuk yang ada d gambar 3. Bentuk dan potong kawat agar bisa dijadikan sungutnya kupu-kupu (bisa juga menggunakan sari bunga yang biasa dipakai untuk membuat bunga plastic) 4. Ambil lembaran flanel yang sudah dipotong, kemudian lem kedua sisi pada bagian tengahnya.

Upload: rhyna-neenna-quenssztt

Post on 27-Oct-2014

97 views

Category:

Documents


1 download

TRANSCRIPT

Page 1: Cara Mbuat Bros

1. Sediakan bahan-bahan standar buat bikin kerajinan flanel… Kain flanel, lem uhu dan kawat

(untuk dibikin sungutnya si kupu)

2. Gunting kain flanel sesuai bentuk yang ada d gambar

3. Bentuk dan potong kawat agar bisa dijadikan sungutnya kupu-kupu (bisa juga

menggunakan sari bunga yang biasa dipakai untuk membuat bunga plastic)

4. Ambil lembaran flanel yang sudah dipotong, kemudian lem kedua sisi pada bagian

tengahnya.

Page 2: Cara Mbuat Bros

5. Tekuk kain flanel seperti gambar

6. Satukan bagian pinggir atas kedua kain flanel yang sudah ditekuk seperti gambar

7. Beri lem pada bagian tengah kupu-kupu untuk menempel sungut

Page 3: Cara Mbuat Bros

8. Keudian tempelkan badannya…

9. Tarrrraaaaaa …jadi dehhh…..

10. Untuk mempecantik bisa dibei hiasan manic-manik pada sayap kupu-kupu…….

Page 4: Cara Mbuat Bros

hese are a bit fiddly to make but they are so cute. You can do almost anything with them from

hair pins to rings to necklaces to jacket/hat pins. And you can use up that bit of scrap fabric you

can't bare to part with for that perfect project. Well you just found it. It looks like a long tutorial,

but I've tried to get every step in there and as clear as possible. You can see more pretty flowers

on my blog :www.theaftercraft.blogspot.com/

Instructions 

1. 1

Before you begin you want to starch your fabric.

If you don't have access to this you can use fabric interfacing as well.

2. 2

Pick out your scrap fabric.

3. 3

Cut out your squares. Any size really will do.

Page 5: Cara Mbuat Bros

Mine were about 2 inch wide so I decided to use 6 petals, but you can use 5 or if you want use

more just your petals won't be as open when you're finished.

4. 4

fold in half

5. 5

Fold corner to the center

6. 6

Same thing to the other side

7. 7

Page 6: Cara Mbuat Bros

Flip over, the two ends that are together are at the bottom of the diamond as we're looking at

it now.

8. 8

Imagine a line going down the middle if the diamond.

Fold the side to the middle.

9. 9

Same thing to the other side.

10. 10

Page 8: Cara Mbuat Bros

Taking your need and thread.( yes no thread in this photo) 

Push the needle through the middle.

See the next photo for a more exact placement.

14. 14

See how the needle catches the little triangles in middle?? That's what we want.

15. 15

Stack em all together and get them on the needle and on to the thread.

I quatruple up on my thread to make it strong.

16. 16

Now you want to cutt off the ends.

Closer picture next step.

17. 17

Page 10: Cara Mbuat Bros

Nice and tight. Give it a few knots so it won't come undone. Then snip your threads.

Should look like this.

21. 21

Push the centre piece out and flat to al the petals

22. 22

should look like this now...

23. 23

Sew on your center AND TA DA!!!! cute and sweet!!

Latest versions 

Page 14: Cara Mbuat Bros

By SyntheticStars

By LaAlex

 originally saw this project on Martha Stewart online. I tweaked it a little bit and I added pictures

and more description to the project. This is my first how-to project on here, so I hope you find it

helpful. I realize that I put a lot of steps that most people will think are "no brainers," but I did not

want to assume that people would know what to do. Once you have made a few flowers, you'll

automatically do the steps without thinking about it. If you have any questions, let me know.

Instructions 

1. 1

Page 15: Cara Mbuat Bros

Gather your materials: 

1. hot-glue gun and hot-glue sticks 

2. scissors 

3. newspaper (so the hot-glue doesn't ruin your table) 

3. zipper (ideally, you want a 36-inch zipper, but a 30-inch one will do the trick; make sure it is

not much smaller or else you will run out of zipper)

I bought my zippers from JoAnn Fabrics and I used competitor coupons. I called and asked the

store if I could do this before I came in, and that came in handy when the cashier was not sure

about what the competitor coupons could be used on. I recommend you call your JoAnn store

before shopping there. I found a good website for zippers, too, but I haven't shopped there yet:

http://www.zipperstop.com/

2. 2

Take the price tag off. Unzip the zipper down towards the bottom. The zipper pull should

become free from one side, but still remain attached to the other, as shown.

3. 3

Page 16: Cara Mbuat Bros

Cut off the plastic zipper stops from each end and slide the zipper pull off of the end it was

attached.

4. 4

Once you've done that to both sides, this is what you should have.

5. 5

The opposite end of the zipper (the end opposite of the one you just cut off) will have a longer

piece of fabric. Dab some glue on this section.

6. 6

Fold the end over onto the glue. Press it with your fingers, but be careful not to burn yourself.

7. 7

Page 17: Cara Mbuat Bros

Put some more glue next to this fold.

8. 8

Roll the fabric over. This will be the center of the flower. Press down to secure the fabric in

place. Be careful not to burn yourself from the hot-glue.

9. 9

Place a dab of glue further away, about an inch or two. The center of your flower (shown on the

right side of the picture) will need to be folded onto this dot of glue.

10. 10

Page 18: Cara Mbuat Bros

When you fold the center of the flower onto this dot of glue, a small loop will have been made.

In this picture, you can see the small gap that the loop has made in between the center of the

flower and the loop you made.

11. 11

Do this step again so you have one loop on each side of the center part of the flower. It should

start to look sort of like an oval.

12. 12

Dab some more hot-glue an inch or two away from your oval-y loop.

13. 13

Page 19: Cara Mbuat Bros

Take your oval-y loop and twist it then stick it directly on top of the dab of glue. The zipper

should be perpendicular to the oval-y loops you made.

14. 14

This is what the bottom of your flower should look like now. You can see that now, instead of

looking like a sushi roll, it has a flat back.

15. 15

Keep dabbing glue and twisting the zipper to form loops around the center of the flower. These

will be your petals.

16. 16

Page 20: Cara Mbuat Bros

Just before your last petal is made, this is what your flower should look like. The long tail will

make up your last petal.

17. 17

Turn your flower over and dab some hot-glue in the center.

18. 18

Take the tail, twist it to make a petal, and secure it to the underside of the flower, where you

put the glue. Press down to secure it, but make sure you don't burn your fingers.

19. 19

Page 21: Cara Mbuat Bros

Cut of the extra leftover tail so you can't see it sticking out underneath the flower. If you want

to, you can use Fray Check to stop the zipper fabric from fraying. Or you can carefully pass the

end (frayed part) quickly back and forth through the flame of a lighter, but be careful.

20. 20

You're all done! If you want to attach your flower to something, you can add felt or fabric to the

underside and then attach that to whatever you want (headband, pin, blouse, gift wrapping,

etc.).

You can also use different kinds of zippers to create your own unique look. I picked zippers with

plastic zipper teeth because they were less expensive, but you can pick zippers with metal

teeth. That gives the flower a harder edge to it, which contrasts nicely with the organic shape

of the flower.

Latest versions 

Page 24: Cara Mbuat Bros

By dominique r.

Instructions 

1. 1

Gather supplies:

2. 2

With thre right side down, place a glue dot on the tip of one of the ends. Stick together oposite

ends so that you are left with a triangle. Now that you have the right side of the fabric on top,

place a dot of glue on the corner that had glue before.

3. 3

Page 25: Cara Mbuat Bros

Now fold the left corner until the tip is glued to the bottom tip. Place a dot of glue over this

union.

4. 4

Fold the Right corner so the tip get glued to the bottom tip.

5. 5

Secure with a clothes pin until the glue dries.

6. 6

Page 27: Cara Mbuat Bros

as shown.

10. 10

Secure it with the Clothes Pin until it dries.

11. 11

Cut the tip off the petal, make sure its straight!

12. 12

Dab some glue on the freshly cut side...

13. 13

Page 28: Cara Mbuat Bros

and press it together with the clothes pin.

14. 14

Repeat steps 1- 11 untill you have enough petals to make a flower. When you do, cut out a

circle of the backing material of your choice. I used green craft felt.

15. 15

Shape the petals with your fingers until they look good. Please make sure the glue is dry by

then or they will unfold. Turn each petal around and place a dot of glue on the bottom. In this

step I used hot glue to save time.

16. 16

Page 29: Cara Mbuat Bros

Add a button on the center or any embelishments you like. These flowers can be worn on

anything. I glue this one to a head band. I made soem felt leaves to add more color:D

17. 17

Now time to rock my new hair piece!

Comments and Criticism appreciated!

Latest versions 

By angelina a.